Pioneer AVIC-F310BT - Manual (Page 104)

1 Display the “Initial Setting” screen.
= For details, refer to Displaying the
“Initial Setting” screen on the previous
page.
2 Turn MULTI-CONTROL to select “Auto
PI
”.
3 Press the centre of MULTI-CONTROL to
switch between
“On” and “Off”.
Switching the auxiliary setting
It is possible to use auxiliary equipment with
the navigation system as the one of sources.
Activate the auxiliary setting when using aux-
iliary equipment connected to the navigation
system.
1 Display the
“Initial Setting” screen.
= For details, refer to Displaying the
“Initial Setting” screen on the previous
page.
2 Turn MULTI-CONTROL to select
“AUX”.
3 Press the centre of MULTI-CONTROL to
switch between
“On” and “Off”.
Setting the rear output and
subwoofer controller
The navigation system
’s rear output can be
used for a full-range speaker or subwoofer
connection. If you switch
S/W Control to
Rear SP:S/W, you can connect a rear speaker
lead directly to a subwoofer without using an
auxiliary amp.
Initially, the navigation system is set for a rear
full-range speaker connection
(
Rear SP:F.Range).
1 Display the
“Initial Setting” screen.
= For details, refer to Displaying the
“Initial Setting” screen on the previous
page.
2 Turn MULTI-CONTROL to select “S/W
Control
”.
3 Press the centre of MULTI-CONTROL to
switch between
“Rear SP:F.Range” and
“Rear SP:S/W”.
When no subwoofer is connected to the rear
output, select
Rear SP:F.Range.
When a subwoofer is connected to the rear
output, select
Rear SP:S/W.
p Both rear speaker leads output and RCA
rear output are switched simultaneously in
this setting. (When you use the product
without RCA rear output, this setting only
applies to the rear speaker leads.)
Setting the rear output
1 Display the
“Initial Setting” screen.
= For details, refer to Displaying the
“Initial Setting” screen on the previous
page.
2 Turn MULTI-CONTROL to select
“Pre-
out
”.
3 Press the centre of MULTI-CONTROL to
switch between “Subwoofer” and
“Rear”.
Switching the sound
muting/attenuation
You can select the muting method when the
voice guidance is output.
p When you use a mobile phone connected
with Bluetooth technology (dialling, talking,
incoming call), the audio source volume is
always muted independently of this setting.
1 Display the
“Initial Setting” screen.
= For details, refer to Displaying the
“Initial Setting” screen on the previous
page.
Customising the initial settings
Engb
104
Chapter
23