Olympus LS-3 - Manual (Page 36)

2
36
EN
R
e
cording
Recording
Note
• If you are unable to produce a clear
recording with this recorder even after
adjusting the recording level (
☞ P.51), this
could potentially be because the output
level for the connected devices is too
high or too low. When external devices
are connected, perform a test recording
and then adjust the output level for the
external devices.
Recording the sound of other devices
with this recorder:
The sound can be recorded when
connecting to the audio output terminal
(earphone jack) of the other device and the
MIC jack of the recorder with the connecting
cord KA333 (optional) for dubbing.
Note
• When you adjust the various sound
quality settings related to playback on
the recorder, the audio output signal sent
out from the EAR jack will change as well
(
☞ P.57, P.59).
Recording the sound of this recorder
with other devices:
The sound of this recorder can be recorded
to other devices by connecting the audio
input terminal (microphone jack) of other
devices and the EAR jack of this recorder,
with the connecting cord KA333 (optional).
To MIC jack
To audio output
terminal of other
devices
To EAR jack
To audio input
terminal of other
devices
• When the external stereo microphone
is used while [Rec Mode] is set to a
monaural recording mode, it enables
recording only with the L channel
microphone (
☞ P.51).