Olympus µ 1050 SW - Manual (Page 13)

1 EN
Setting the date and time
The date and time set here are saved to image
file names, date prints, and other data.
1
Press the o button to turn on
the camera.
The date and time setting screen is displayed
when the date and time are not set.
X
Y M
Y M D
D TIME
---- -- -- -- --
MENU CANCEL
Date and time setting screen
2
Use
12 to select the year for [Y].
2008 -- -- -- --
X
Y M
Y M D
D TIME
MENU CANCEL
3
Press the
o button to save the
setting for [Y].
2008 -- -- -- --
X
Y M
Y M D
D TIME
MENU CANCEL
●
4
As in steps 2 and 3, use
1234
and the
o button to set
[M] (month), [D] (day), and
[TIME] (hours and minutes).
For precise time setting, press the o button
as the time signal strikes 00 seconds.
To change the date and time, make the
setting from the menu. [X] (Date/time)
(p. 45)
To check the date and time
Press the g button while the camera is
turned off. The current time and alarm time
are displayed for approx. 3 seconds.
Changing the display language
The language for the menu and error messages
displayed on the monitor is selectable.
1
Set the mode dial to a position other
than
R, 6.
2
Press the
 button, and press
1234 to select [x SETUP].
SCN
RESET
PANORAMA
CAMERA
MENU
SILENT
MODE
MENU EXIT SET OK
IMAGE
QUALITY
SETUP