Olympus C-4040 Zoom - Manual (Page 90)

90
Chapter 5
Sequential shooting (Cont.)
4 Take pictures.
● Press the shutter button all the way and
keep it pressed to shoot the preset
number of pictures. You can stop shooting
at any time by releasing the shutter button.
Auto bracket
Control panel
Mode dial & Drive mode
Mode dial Drive mode Factory default setting
P
ࠗ
Single-frame shooting
A/S/M
ࠗ (M: BKT is not available)
Single-frame shooting
– –
● Sequential shooting (
, , BKT) is not possible in the TIFF record
mode (P. 103).
● If the SHQ record mode is set to ENLARGE SIZE (P. 106), sequential
shooting ( , , BKT) is not possible.
● When NOISE REDUCTION is ON, sequential shooting (
, , BKT) is
not possible.
● During sequential shooting (
, , BKT), the main flash does not fire.
● If there is not enough space available on the card for the number of frames
you have set during auto bracketing, you cannot continue shooting.
● If the ISO is set to over 200, noise may appear under some shooting
conditions (P. 107).
● If the battery power is low and the battery check blinks during sequential
shooting, shooting stops and the camera starts saving the pictures you
have taken. Whether or not all of the shots are saved depends on how
much battery power remains.
● Since the shutter speed is set to 1/30 sec. max., exposure is decreased
when shooting a dark subject to prevent camera movement.
● To use the external flash during sequential shooting, set the external flash
so that it fires for each frame.