Remote control shooting (cont.), Chapter 11 – Olympus C-4040 Zoom User Manual
Page 181

181
Remote control shooting (Cont.)
Chapter 11
4
Press the shutter button on the remote control.
● The camera’s self-timer/remote control lamp blinks for about 3 seconds
before taking the picture.
● If the remote control receiver is exposed to strong light, the effective
frequency area may be reduced or shooting may not be take place.
● In the P and A/S/M modes, only single-frame shooting is possible with the
remote control. Sequential shooting is not available.
● Read the remote control’s instructions for information on playback with the
remote control.
● If the camera’s self-timer/remote control lamp does not blink after
pressing the shutter button on the remote control.
T The remote control may be too far from the camera. Move closer to
the camera and press the shutter button again on the remote control.
T There is frequency interference. Change the frequency according to
the remote control’s instructions.
● How to cancel the remote control mode.
T The remote control mode is not canceled automatically after shooting.
Perform step 2 on page 180: In the still picture shooting mode set
DRIVE to any other setting except
, and in the movie recording
mode set
to OFF.
TIPS