Olympus EVOLT E-510 - Manual (Page 38)

38
EN
Sho
oting fun
ctions
k
Various shooting functions
3
e.g.) When BKT is set to [3F 1.0EV]
Compensation value: 0.3, 0.7 or 1.0
The exposure compensation value will change if the EV step is changed. The EV step can be
changed using the menu. Exposure compensation value can be adjusted within a range of
±1.0.
g “EV step” (P. 78)
Number of frames: 3
MENU[X][AE BKT]
[OFF]/[3F 0.3EV]/[3F 0.7EV]/[3F 1.0EV]
Start shooting.
• The shooting method varies depending on the setting of
single-frame or sequential shooting. g “Sequential
shooting” (P. 45)
Single-frame shooting
Each time the shutter button is pressed fully, a picture is
taken at a different exposure.
• The setting for the next shot is displayed in the viewfinder.
Sequential shooting
Hold down the shutter button until the selected number of frames are taken. The camera
shoots each frame at a different exposure.
• Releasing the shutter button stops auto bracketing shooting. When it stops,
0 on the control
panel is displayed in green.
How AE bracketing compensates exposure in each exposure mode
Depending on the selected exposure mode, exposure is compensated in the following way:
P mode : Aperture value and shutter speed
A mode : Shutter speed
S mode : Aperture value
M mode : Shutter speed
TIPS
To apply AE bracketing to the exposure value you have compensated:
J Compensate the exposure value, then use the AE bracketing feature. AE bracketing is applied to
the exposure value you have compensated.
Menu
x Notes
• During sequential shooting, if the battery check blinks due to low battery, the camera stops
shooting and starts saving the pictures you have taken on the card. The camera may not save
all of the pictures depending on how much battery power remains.
-1.0EV +1.0EV ±0
CANCEL GO SELECT
Viewfinder
Exposure
compensation
value of the
next shooting
frame
s0010_e_00_unified.book Page 38 Monday, April 9, 2007 6:12 PM