Aiwa BMZ-K1 - Manual (Page 16)

16
En
TIMER OPERATIONS
Sleep timer
Turns off the unit automatically after a specified time.
Press SLEEP on the remote.
"SLEEP" flashes in the display.
With each press, the timer duration changes as follows:
AUTO
10...70 OFF
90 80
If you set to "AUTO", the unit turns off automatically when
the current CD finishes playback or elapsed 100 minutes.
To check the remaining time until the unit turns off
Press SLEEP on the remote. The remaining time is displayed
for 6 seconds.
To cancel the sleep timer
Press SLEEP on the remote repeatedly so that "OFF" is
displayed.
Timer playback
Turns on the unit at a specified time for the specified duration.
Make sure the clock is set correctly.
1 Press CLOCK/TIMER SET on the remote to
display "DAILY".
2 Press ENTER.
"5" indicator lights up and "ON" appears in the display.
3 Press r or t to set the timer start hour,
and press ENTER.
4 Press r or t to set the minute, and press
ENTER.
"OFF" is displayed.
5 Set the time to stop playback by following the
same procedures as steps 3 and 4.
6 Press r or t to select the source (CD and
TUNER), and press ENTER.
7 Prepare the source.
To play CD, load disc(s).
To play the radio, select the band and tune in the desired
station.
8 Press POWER 6STANDBY/ON (POWER) to turn
the unit off.
"5" remains in the display to indicate the timer standby
mode (when ECO mode is deactivated).
At timer-on time, the unit turns on and plays the selected
source. After the specified timer-activated duration, the
unit turns off again.
•MULTI JOG is also available in place of r or t.
•To stop timer setting in steps 3 to 5, press CLEAR.
Timer standby mode is also cancelled.
•The timer playback is not activated when the clock is not
set. ("SET NG" is displayed.)
•Timer playback will not begin unless the unit is turned off
first.
•Timer playback for AUX function is not possible.
To check the timer setting
Press CLOCK/TIMER SELECT on the remote repeatedly to
display “DAILY”.
The timer-on time, the time to stop playback and the source
are displayed for 6 seconds.
To change the timer setting
Reset the timer again.
To cancel the timer
Press CLOCK/TIMER SELECT on the remote repeatedly to
display “OFF”. 5 disappear from the display.
Tip:
Your timer setting is retained even if the timer is cancelled.
Next time the timer is activated, you can change your previous
setting, or simply use the same setting again.
POWER
CLEAR
POWER
6STANDBY/ON
ENTER
r
MULTI JOG
t
r,t ENTER
SLEEP
CLOCK/TIMER
SELECT
CLOCK/TIMER
SET