Asus M2A-MVP - Manual (Page 42)

1-30 Chapter 1: Product introduction
4. Chassis intrusion connector (4-1 pin CHASSIS)
This connector is for a chassis-mounted intrusion detection sensor or switch.
Connect one end of the chassis intrusion sensor or switch cable to this
connector. The chassis intrusion sensor or switch sends a high-level signal to
this connector when a chassis component is removed or replaced. The signal
is then generated as a chassis intrusion event.
By default, the pins labeled “Chassis Signal” and “Ground” are shorted with
a jumper cap. Remove the jumper caps only when you intend to use the
chassis intrusion detection feature.
M2A-MVP
M2A-MVP Chassis intrusion connector
CHASSIS
+5VSB_M
B
Chassis Signal GND
(Default)
• Plug your Serial ATA boot disk on the master port (SATA1/2 to support S3
function).
• Install the Windows ® 2000 Service Pack 4 or the Windows ® XP Service Pack1
or later when using Serial ATA.
Connector Color Setting Use
SATA1/SATA2 Red Master Boot disk
SATA3/SATA4 Black Slave Data disk
Serial ATA hard disk drive connection