Installation, 2 unpacking – AEG L87695WD User Manual
Page 31
Problem
Possible cause
Possible solution
You have set a wrong
dryness level or drying
time.
Set additional drying time.
There is a big
quantity of fluff in
the drum.
The fabrics washed in the previ-
ous cycle released fluff of a dif-
ferent colour:
• The drying phase helps to
eliminate some fluff.
• Clean the clothes with a fluff
remover.
In case of an excessive amount
of fluff in the drum run the spe-
cial programme to clean it (refer
to “FLUFF IN THE FABRICS” for
more details).
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
service centre.
If the display shows other alarm codes,
contact the service centre.
15. INSTALLATION
15.1 Fixing plate kit
(4055171146)
Available from your authorized dealer.
If you install the appliance on a plinth,
secure the appliance in the fixing plates.
Follow the instructions supplied with the
kit.
15.2 Unpacking
1.
Use the gloves. Remove the external
film. If necessary, use a cutter.
ENGLISH
31