beautypg.com

Troubleshooting, 10 frost precautions – AEG L87695WD User Manual

Page 28

background image

Put the drainage duct back and close the
drain pump flap.
When you drain the water with the emer-
gency drain procedure, you must acti-
vate again the drain system:

1.

Put 2 litres of water in the main wash
compartment of the detergent dis-
penser.

2.

Start the programme to drain the
water.

13.10 Frost precautions

If the appliance is installed in an area
where the temperature can be less than
0 °C, remove the remaining water from
the inlet hose and the drain pump.

1.

Disconnect the mains plug from the
mains socket.

2.

Close the water tap.

3.

Remove the water inlet hose

4.

Put the two ends of the inlet hose in
a container and let the water flow
out of the hose.

5.

Empty the drain pump. Refer to the
emergency drain procedure

6.

When the drain pump is empty, in-
stall the inlet hose again.

WARNING!
Make sure that the temperature
is more than 0 °C before you use
the appliance again.
The manufacturer is not responsi-
ble for damages caused by low
temperatures.

14. TROUBLESHOOTING

The start of the appliance does not oc-
cur or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
service centre.

With some problems, the acoustic
signals operate and the display shows
an alarm code:

- The appliance does not fill with

water properly.

- The appliance does not drain

the water.

- The appliance door is open or

not closed correctly.

- The anti-flood device is on.

WARNING!
Deactivate the appliance before
you do the checks.

Problem

Possible cause

Possible solution

The appliance
does not fill with
water.

The water tap is closed.

Open the water tap.

The water inlet hose is
damaged.

Make sure that the water inlet
hose has no damages.

The filters in the water
inlet hose is blocked .

Clean the filters. Refer to 'Care
and cleaning'.

The water tap is blocked
or is furred with lime-
scale.

Clean the water tap.

The connection of the
water inlet hose is not
correct.

Make sure that the connection
is correct.

The water pressure is
too low.

Contact your local water author-
ity.

28 www.aeg.com