AEG L87695WD - Manual (Page 19)

• Press button 1 to deactivate the ap-
pliance. After five minutes from the
end of the programme, the energy
saving function automatically deacti-
vates the appliance.
When you activate the appliance
again, the display show the end
of the last set programme. Turn
the programme knob to set a
new cycle.
• Remove the laundry from the appli-
ance. Make sure that the drum is emp-
ty.
• Keep the door ajar, to prevent mildew
and odours.
• Close the water tap.
The washing programme is
completed, but there is water in the
drum:
– The drum turns regularly to prevent
the creases in the laundry.
– The door stays locked.
– You must drain the water to open the
door.
To drain the water:
1. If necessary, decrease the spin
speed.
2. Press the Start/Pause button 4 .
The appliance drain the water and
spin.
3. When the programme is completed
and the door lock symbol goes off,
you can open the door
4. Deactivate the appliance.
The appliance drain and spin au-
tomatically after approximately
18 hours.
10. USING THE APPLIANCE - DRYING ONLY
WARNING!
Open the water tap. Put the drain
hose in the sink or connect to the
drain pipe.
• Load the laundry.
• Turn the programme dial to the pro-
gramme suitable for the items to dry.
The drying symbol comes
on.
To have best performances in
drying when you wash the laun-
dry set a spin cycle at the maxi-
mum speed allowed for your
type of items.
You can dry your laundry in two ways:
With the automatic drying:
• press the button 8 again and again
until a black line appears under one of
the dryness level symbol:
Extra dry symbol
Cupboard dry symbol
Iron dry symbol
• The display shows a time value, calcu-
lated on a default load size. If the
amount of your laundry is more or less
than the default size, the appliance
adjusts automatically the time value
during the cycle.
• Press the button 4 to start the pro-
gramme.
The door locked symbol
comes on.
The drying symbol starts to
flash.
You cannot set all levels for all
type of laundry.
With the timed drying:
• Press the button 7 again and again
to set the drying time value (see the
«Programme for timed drying» table).
The display shows a minimum time
value.
ENGLISH
19