AEG Micro-Processor Charging Unit LP 3.8 - Manual (Page 14)

14
the manufacturer is not responsible for damages
caused by:
▪
improper connection and / or operation.
▪
Exterior force, damage to the device and /
or damage to parts of the device caused by me-
chanical impact or overload.
▪
any type of modification to the device.
▪
Use of the device for purposes that are not de-
scribed in this instruction manual.
▪
Consequential damages caused by non-intended
and / or improper use, and / or defective batteries.
▪
moisture and / or insufficient ventilation.
▪
the unauthorised opening of the device. this will
void the guarantee.
Safety notices for chargers
▪
keep the device away from children. Children do
not understand or perceive possible risks when han-
dling electrical devices. Children must be supervised
to ensure that they do not play with the charger.
▪
Ensure that the device is always stored in a safe
place. Do no expose the device to rain or wet con-
ditions. avoid pouring or dripping water or other
liquids over it. if water penetrates electrical devices,
the risk of electric shock increases.
▪
Ensure that all plugs and cables are free of mois-
ture. Never connect the device to the mains with wet
or moist hands.
▪
Do not touch the battery poles, the battery clamps
or the ring connectors while the device is connected
to the mains.
▪
remove all device cables from the battery before
attempting to drive your vehicle.
▪
always disconnect the device from the mains when
you are not using it.
▪
always disconnect the device by pulling out the
power plug, never by unclamping a connecting
cable.
▪
if the cables need to be run through walls with
sharp edges, for example metal sheets, use tubes
or cable ducts to prevent damage to the cables. Lay
electrical cables in such a way that it is not possible
to stumble over them, thereby preventing damage.
▪
Never place the device over or close to the battery
to be charged. gases from the battery make the
charger corrode and damage it. set up the charger
as far away from the battery as the direct current
cable allows.
▪
Do not cover the device while charging.
▪
Never pull the cable or use it to carry the device.
Damaged cables increase the risk of electric shock.
▪
only operate the device if all cables and the casing
are intact.
iNtroDUCtioN
always follow these instructions when using
this product.
include all documentation when transferring
the product to other users.
images may slightly deviate from the actual product.
subject to change in the interest of technical advances.
Decorations not included.
Contents
Be sure to verify contents immediately upon opening
the product. Check the product and all parts for dam-
age. Do not use a defective product or parts.
1 Charger
▪
terminal cable with terminal clamps
+ (positive, red) and – (negative, black)
▪
terminal cable with ring terminals
+ (positive, red) and – (negative, black)
1 operating manual
saFEtY
General Safety Guidelines
read all safety guidelines and instructions. Non-
compliance with safety guidelines and instructions
can cause electric shock, fire and / or serious injury.
keep all safety guidelines and instructions for future
reference.
Warning!
Life-threatening danger to infants and
children!
Never leave children unsupervised with the
packing material as this can cause suffocation.
this device is not intended for use by persons (includ-
ing children) with reduced physical, sensory or mental
abilities or who lack experience and / or knowledge,
unless they are supervised by a person who is respon-
sible for their safety or unless they receive instructions
from this person on how the equipment is to be used.
Children must be supervised in order to ensure that
they do not play with the device.