AEG Micro-Processor Charging Unit LW 60.0 - Manual (Page 35)

GB 35
Error/Problem Possible cause Correction
Battery cannot be
charged no power supply, charger not
plugged in Verify the charger is
plugged into a 230 V
mains outlet and the
“Power” leD (15) is
on Battery may be
defective
long charging
time only a very low charging current
is used in very low temperatures
(below 0 ˚c) This will extend
the charging time as the battery
warms up, the charging current is
adjusted accordingly charge battery in
normal conditions
explosion hazard!
never charge frozen
batteries
Battery capacity too high for the
charger being used use a suitable
charger
Battery voltage
too low Battery wasn’t charged long
enough ensure the battery
is charged long
enough
cleanInG, care anD MaInTe-
nance
▪
clean clamps after every charging To prevent corrosion, wipe off any battery
fluid which may have come into contact with the clamps
▪
carefully wind the cable when storing the device This will help prevent acciden-
tal damage to the cable and the device
▪
clean the product with a soft, dry cloth
▪
store the machine in a clean, dry place