AEG Micro-Processor Charging Unit LW 60.0 - Manual (Page 27)

GB 27
Risk of electrical shock!
▪
chargers may interfere with the operation of active electronic implants, eg
pacemakers, thus pose a personal hazard
▪
avoid pouring or dripping water or other liquids over it If water penetrates
electrical devices, the risk of electric shock increases
▪
ensure that all plugs and cables are free of moisture never connect the device to
the mains with wet or moist hands
▪
never touch both connections at once when the device is in uses
▪
unplug from mains before connecting or disconnecting the charging cable with
the battery, or when the device is no longer being used
▪
remove all device cables from the battery before attempting to drive your vehicle
▪
always unplug device by the plug The cable may be damaged
▪
Do not use device if damaged Damage to the power cable, the device or the
charging cable increase the risk of electrical shock
▪
Do not attempt to disassemble or repair the device Immediately have a defective
device or damaged power cable repaired or replaced by a speciality shop
▪
risk of short circuits! Do not allow the two connectors from the charging cable to
touch if the power plug is plugged into the power outlet Be sure not to connect
the connectors or the battery poles through conductive objects (eg tools)
▪
never use the cable to carry or pull the device
Risk of injury!
▪
never attempt to charge non-rechargeable, damaged or frozen batteries
▪
Do not use this device to charge dry cell batteries These could burst, resulting in
personal injury and property damage
▪
Please read and follow the operating manual and all safety instructions for the
batteries to be charged and the vehicle before using this device
Risk of damage!
▪
never place the device over or near the battery to be charged Gasses from the
battery could damage the unit Place the device as far from the battery as the
connecting cable will allow
▪
never operate the device if it has been dropped or damaged in any other way
for inspection and repair, take it to a qualified electrician