Apple COLOR STYLEWRITER 2400 - Manual (Page 58)

6 When you see a message on your screen, follow the directions and insert the next disk.
The Installer ejects disks and asks you to insert others. Keep following the
instructions on the screen until the installation is complete.
7 When you see a message reporting that installation was successful, click Restart.
The Installer restarts your Macintosh.
The Macintosh doesn’t recognize the Color StyleWriter 2400
If you have selected the Color StyleWriter 2400 printer in the Chooser but
nothing prints, or you get a message that no Color StyleWriter 2400 is
connected, one of the following conditions may be the cause:
m A plug is loose. Make sure that all cables are properly connected. See the
instructions in Chapter 1 for setting up your Color StyleWriter 2400.
m You may have indicated the wrong port in the Chooser. Open the Chooser
and change the port selection. (If possible, check to see whether you
plugged the printer into the computer’s printer port [
[ ] or modem port
[ W ], then make sure that you indicate the same port in the Chooser.)
m If you are trying to use a shared printer connected to another Macintosh
and the printer name isn’t listed in the Chooser, make sure that the other
Macintosh is turned on and connected to the network. Also make sure that
the printer is set up to be shared. Then try again to select the printer in the
Chooser. See the instructions in “Sharing Your Printer With Other Users”
in Chapter 2.
m If you’re using a PowerBook computer with an internal modem, change the
serial port setting to Normal or External. For details, see “Special
Information for PowerBook Owners” in the section “Telling Your
Computer to Use the Color StyleWriter 2400” in Chapter 1.
If you still can’t resolve the problem, the printer may not be working properly.
See the information about service and support that comes with your printer.
Troubleshooting 53