Konica Minolta bizhub C352 - Manual (Page 23)

2 Administrator Operations
2-4 C352
Ad
minist
ra
to
r Op
er
at
ions
Chapter 2
3
Enter the 8-digit Administrator Password from the keyboard and key-
pad.
– Press the [C] key to clear all characters.
– Touch [Delete] to delete the last character entered.
– Touch [Shift] to show the upper case/symbol screen.
– Touch [Cancel] to go back to the screen shown in step 2.
4
Touch [OK].
? What happens if a wrong Administrator Password is entered?
% If a wrong Administrator Password is entered, a message appears
saying that there is a mismatch in the Administrator Passwords and
entry of the Administrator Password will be prohibited for five sec.
Wait for some while before entering the correct Administrator Pass-
word.
% If the Enhanced Security mode is set to [ON], entry of a wrong pass-
word is counted as unauthorized access. If a wrong Administrator
Password is entered a predetermined number of times (once to
three times) set by the Administrator of the machine or more, a
message appears saying that the machine accepts no more Admin-
istrator Passwords because of unauthorized access for any subse-
quent entry of the Administrator Password. The machine is then set
into an access lock state. To cancel the access lock state, turn off,
and then turn on, the main power switch of the machine. When the
main power switch is turned off, then on again, wait at least 10 sec-
onds to turn it on after turning it off. If there is no wait period be-
tween turning the main power switch off, then on again, the
machine may not function properly.
Here is the sequence, through which the main power switch and
sub power switch are turned on and off:
Turn off the sub power switch
→ Turn off the main power switch →
Turn on the main power switch → Turn on the sub power switch
5
Press the [Utility/Counter] key to log off from the Administrator Setting
mode.
c352_security_E.book 4 ページ ２００７年４月１１日 水曜日 午前１０時５２分