Konica Minolta bizhub PRESS 1250 - Manual (Page 139)

Parameter Option Description
Generate
corner mark Select Generate corner mark to print correct corner marks on
sheets. The long line is parallel with the lead edge of a sheet and the
short line is perpendicular to the lead edge of a sheet.
The SCC measures distance both horizontally and vertically. Based
on measured distance, SCC manages slit positions, cut positions,
and crease positions. The Reference position is the start point to
measure the Finished size and the Crease position.
Note: When the CCD Scanner is not active, the actual corner of each
sheet is the starting point to measure distance.
Generate
barcode Select Generate barcode to place the barcode in any corner of the
page with offsets and in front or back side of the sheet. Type the
distance in mm.
Note: The IC-309m print controller allows you to place the
registration mark and barcode in any corner of the page with offsets
(in-track and cross track).
Position Generates a barcode in the following location of the page: Top right,
Top left, Bottom right, and Bottom left.
Side Select the side where the barcode will be generated. Select Front
side or Back side.
Registration
line offset Paper width direction—the whole registration mark is placed within
3 mm -20 mm from the right edge.
Note: This option is available for the DC-645.
Corner mark
offset The corner mark is placed in a range of 0 - 25 mm (horizontal and
vertical distance).
Note: This option is available for the DSF-2000.
Barcode
offset Paper feed direction—The whole barcode should be within 3 mm- 20
mm from lead edge Paper width direction: The whole barcode should
be within 25 mm - 60 mm from the right edge.
End mark The Duplo DSF-2000 includes an end mark detector that can detect
collation and paper feed errors, and prevents binding errors.
Finishing tab in the job parameters window 131