Konica Minolta bizhub PRO 1200 User Manual
Page 60
4
Using Perfect Binder PB-503
56
bizhub PRO 1200/1200P/1051 Additional Information
10
Specify the cover trimming setting.
–
Touch [On] to trim the cover, or [Off] to deactivate this function.
If the trimming width estimated by the machine does not fall within
the range from 3 to 40 mm, a message will be displayed to inform
you that the trimming mode is unavailable. In this case, adjust the
cover or spine width to enable this setting.
If the estimated amount exceeds 10 mm, perfect binder will auto-
matically trim the cover whether this function is activated or not.
11
Make fine adjustments on the lead edge, trimming width, and image
position of the cover.
–
Touch [Change Set] on the right side of Fine Adjustment to display
the Fine Adjustment Screen.
–
To adjust the lead edge of the cover, touch [Cover Lead Edge Adj.].
Use the screen keypad, [
+] and [,], or the control panel keypad to
enter the desired value, then touch [+<->–] to select positive or neg-
ative of the adjustment value.