Konica Minolta bizhub PRO 1200 - Manual (Page 43)

Using Perfect Binder PB-503 4
bizhub PRO 1200/1200P/1051 Additional Information 39
2
Note
Once started, the warmup of the heater will not be interrupted even when
the Auto Low Power/ Auto Shut Off functions on the main body.
2
Reminder
Once [Perfect Bind] touched on the Output Setting Screen, the heater of
the perfect binder will continue warming up even though the setting is re-
leased with [Function Off] touched on the Perfect Binding Screen or with
[Reset] pressed on the control panel. If not using the perfect binder, be
sure to turn off the heater by touching the PB switch [OFF] on the Ma-
chine Status Screen.
To turn off the heater of the perfect binder
When the job using perfect binder is completed, the heater of the perfect
binder will automatically be turned off in one minute. The heater will also be
turned off automatically in one minute if any operation has not been made on
the perfect binder after completion of the warmup.
The heater can be turned off manually by touching the PB switch [OFF] on
the Machine Status Screen while warming up or ready for operation,
!
Detail
Service can set the heater not to be turned off automatically after one-
minute interval. Please contact your service representative, if desired. In
this case, the heater will not be turned off till the Auto Low Power/ Auto
Shut Off functions on the main body. Please be careful not to allow the
paste pellets to deteriorate.
bizhub PRO 1200/1051