Konica Minolta SD-501 - Manual (Page 50)

05 Saddle Stitcher Adjustment (continued)
3-14
07 Trimming Adjustment
Perform this adjustment for the position of punch holes to the direction of paper feed.
Procedure
1 Touch Adjustment - 02 Finisher Adjustment - 05 Saddle Stitcher Adj.
2 Touch 07 Trimming Adjustment to display the Trimming Adjustment Screen.
3 Touch the COPY tab to display the Copy Screen.
4 Load the desired size of paper to be adjusted on a tray, specify Fold&Staple,
then press [Start]. A sample pattern (No. 16) will be output.
5 Check the trimmed width (a) from the edge of the feeding sheet.
6 If the desired result cannot be obtained, touch the ADJUSTMENT tab.
7 Touch Next or Back to select the paper size to be adjusted.
Touching Next continuously will change the paper size as follows.
All Size - 11x17 - A3 - B4 - 8.5x14 - A4R - 8.5x11R - B5R - 8x13 - 8.12x13.2 -
8.5x13 - 8.25x13 - 8K - 16KR - 12x18 - A3W - B4W - A4WR - B5WR - 12x18W -
11x17W - 8.5x11WR - Special
a
2.0mm or more