Konica Minolta SD-501 - Manual (Page 42)

05 Saddle Stitcher Adjustment (continued)
3-6
6 If the desired result cannot be obtained, touch the ADJUSTMENT tab.
7 Touch Next or Back to select the paper size to be adjusted.
Touching Next continuously will change the paper size as follows.
All Size - 11x17 - A3 - B4 - 8.5x14 - A4R - 8.5x11R - B5R - 8x13 - 8.12x13.2 -
8.5x13 - 8.25x13 - 8K - 16KR - 12x18 - A3W - B4W - A4WR - B5WR - 12x18W -
11x17W - 8.5x11WR - Special
8 Use the touch panel keypad to enter the desired adjustment value, then touch
Set.
Available range: -20 (wide) to +20 (narrow), 1 step = 0.1 mm
The following limitation is put on the paper width setting according to the
actual paper width.
Using paper size of which actual width is less than 222 mm such as A4R, the
staple pitch will be set to 91 mm automatically even if the value shorter than
91 mm of staple pitch is entered.
9 Repeat the adjustment steps from 3 to 8 until the desired result is obtained.
10 If adjustment in any other paper size is required, repeat steps from 3 to 8.
11 Touch Return to restore the Saddle Stitcher Adjustment Mode Menu Screen.
Actual paper width Minimum value Maximum value
~ 222 mm 91 mm Actual width minus 91 mm
222 mm ~ 290 mm Not limited Not limited
290 mm ~ Not limited 165 mm