Konica Minolta IC-402 - Manual (Page 4)

4
Using the Fiery X3e System Software Service Kit
14. Flip the service switches down to the normal position (away from the interface board).
15. Disconnect the cross-over cable from the LAN port and the Windows 2000/XP PC.
F IGURE D Dismantling the isolated Ethernet network
16. Reconnect all the cables to the Fiery X3e connector panel that you removed earlier.
N OTE : Make sure to attach the interface cable to the print engine, as well as to the
Fiery X3e COPIER port if you used it in this procedure.
F IGURE E Restoring normal configuration
17. Power on the Fiery X3e using its dedicated AC power switch.
N OTE : If the Fiery X3e does not turn on within a few seconds, press the Soft power
button on the connector panel.
18. Touch the language setup icon after it appears in the lower-left corner of the main
copier screen.
19. Select the name of the language that you want to use, and then select OK.
X
Windows 2000/XP PC
LAN port
Ethernet cross-over cable
Customer’s LAN
X COPIER port To print engine
LAN port
Ethernet cross-over cable