Connecting to the network – Konica Minolta IC-402 User Manual
Page 10
10
Using the Fiery X3e System Software Service Kit
Connecting to the network
Depending on your network speed, the following unshielded twisted pair (UTP)
network cables are supported:
• For 10BaseT, Category 3 or higher
• For 100BaseTX, Category 5 or higher (4-pair/8-wire, short-length)
• For 1000BaseT, Category 5e or higher (4-pair/8-wire, short-length)
N
OTE
:
If the print engine is 230V, use a shielded network cable.
The network cable connects to the LAN port on the connector panel of the Fiery X3e
(see Figure J).
F
IGURE
J
Network connectors and service switches
LAN port for 10/100/1000BaseT
twisted pair Ethernet
Service switches
USB Type B port for connection
to a PC for system software
installation and/or printing
USB Type A ports (2) Either can
connect to a USB flash drive for
system software installation