Replacing the fuser unit, Replacing the fuser unit -19 – Konica Minolta magicolor 1650EN User Manual

Page 110

Text mode
Original mode

Replacing Consumables

6-19

Replacing the Fuser Unit

For optimum print quality and performance, use only approved KONICA
MINOLTA fuser unit for your specific printer type.

Turn off the printer and discon-
nect the power cord.

Note

There are extremely hot parts within the printer. Before replacing the
fuser unit, wait about 20 minutes after turning off the printer, and
then check that the fusing section has reached room temperature,
otherwise, you may get burnt.

Open the top cover.

If there is paper in the
output tray, remove it,
and then fold up the out-
put tray before opening
the top cover.