Konica Minolta BIZHUB 223 - Manual (Page 11)

bizhub 423/363/283/223 2-5
2.3 Setup procedures 2
2.3 Setup procedures
Before you can use this printing system, you must complete the setup.
The setup refers to a series of procedures for connecting this machine to the computer and installing the fax
driver to the computer.
Perform the setup using the following procedures.
2.3.1 For network connection
d
Reference
For details on connecting this machine to the computer, refer to [User's Guide Print Operations].
When updating an existing fax driver, uninstall it first. For details, refer to page 3-21.
For network connection, this manual only covers setup procedures for connecting through
Port9100/IPP/IPPS (you use the installer to install the driver) and through LPR/Port9100 (you use the Add
Printer Wizard to install the driver). For details on other setup procedures, refer to the [User's Guide Print Op-
erations].
1
Connect this machine to the computer.
2
Check that the computer to be used is connected to the network.
3
Specify the IP address of this machine, and then connect it to the network.
4
Change the network settings for this machine according to the connection method or protocol.
% LPR: In [LPD Setting], enable LPD printing.
% Port9100: In [TCP/IP Settings], enable the RAW port number (initial setting: [9100]).
% SMB: Configure settings of [Print Settings] in [SMB Settings].
% IPP/IPPS: In [IPP Settings], enable IPP printing.
% Web Service Print: In [Web Service Settings], enable the print function.
5
Install the fax driver.
% Specify the network port for the fax driver according to the connection method or protocol.
2.3.2 For local connection
1
Connect this machine to the computer.
2
Install the fax driver.