Konica Minolta BIZHUB C360 - Manual (Page 34)

bizhub C360/C280/C220 3-11
3.2 [Basic] 3
d
Reference
For details on the paper that can be half-folded, center stapled & folded, stapled, and punched, refer to [Us-
er's Guide Copy Operations].
[Staple/Punch] [Staple]:
Copies can be bound with a staple in the corner or with two staples.
[Punch]:
Copies can be fed out hole-punched.
The number of punched holes varies depending on the country (area)
where this machine is used. For details, contact your service representa-
tive.
[Position Setting] Select the desired staple or hole-punch position.
•
[Auto]:
The staple or hole-punch position is automat-
ically set either at the top or at the left.
A staple or punch position along the long side
of the paper is selected if the original length is
11-11/16 in (297 mm) or less.
A staple or punch position along the short
side of the paper is selected if the original
length exceeds 11-11/16 in (297 mm).
• If [Auto] is selected for the staple or hole-
punch position, load the original with the top
toward the back of the machine.
• If desired, press [Original Direction], and then
specify the direction in which the original is
loaded.
[Fold/Bind] [Half-Fold] Select this setting to fold copies at the center in
half before feeding them out.
[Center Staple &
Fold] Select this setting to staple copies at the center
before feeding them out.
[Main Screen] Press this button to return to the basic settings screen with the changed
settings applied.
Settings
1 1 1