Replacing the diskette drive, Replacing, Diskette – Lenovo ThinkCentre A61 User Manual
Page 30: Drive, Removing, Retaining, Bracket

9.
Align
the
drive
bay
assembly
with
the
two
slots
and
rails
on
the
sides
of
the
chassis,
reconnect
the
drive
cables
on
the
system
board,
and
then
slide
the
drive
bay
assembly
towards
the
rear
of
the
chassis
until
it
snaps
into
position.
10.
Reinstall
the
front
bezel.
11.
Go
to
Replacing
the
diskette
drive
Attention
Do
not
open
your
computer
or
attempt
any
repair
before
reading
the
“Important
safety
information”
in
the
Safety
and
Warranty
Guide
that
was
included
with
your
computer
for
the
computer.
To
obtain
copies
of
the
Safety
and
Warranty
Guide,
go
to
http://www.lenovo.com/support.
This
section
provides
instructions
on
how
to
replace
the
diskette
drive.
1.
Remove
the
computer
cover.
See
2.
Remove
the
bezel
and
drive
bay
assembly.
See
3.
Release
the
diskette
drive
by
pressing
inward
on
the
blue
retainer
at
the
side
of
the
drive.
4.
Remove
the
failing
diskette
drive
by
sliding
it
out
the
front
of
the
drive
bay
assembly.
5.
Remove
the
retainer
bracket
from
the
failing
drive
and
install
it
on
the
new
drive.
6.
Install
the
new
diskette
drive
into
the
drive
bay
from
the
front
until
it
snaps
into
position.
Figure
24.
Removing
the
diskette
drive
Figure
25.
Retaining
bracket
for
diskette
drive
22
Hardware
Installation
and
Replacement
Guide