Lenovo IdeaCentre Q700 - Manual (Page 22)

User Guide
Notes:
. It is recommended that you do not install software which is already on
the computer.
2. Before accessing the operating system, ensure that the Drivers and
Application software has been installed automatically. After that,
the manual installation function can be used. To start the manual
installation, restart the operating system, a prompt dialog will pop up
asking whether or not to continue automatically installing. Click Cancel.
2.2 OneKey Recovery
Main functions:
. If a Windows operating system is preinstalled on your computer, the OneKey
Recovery function works in the following way:
Recover Factory Backup: Recover the computer system partition (drive C) to
the original factory default settings.
Note: After this operation, all existing data in the system partition will
be lost and other partitions on the disk will remain unchanged. In order
to prevent loss of data, be sure to back up important data before this
operation.
2. If a Windows operating system is not pre-installed on your computer, the
OneKey Recovery function will provide the following two functions:
Create base backup: In the absence of the factory backup, the Lenovo
OneKey Recovery system enables you to back up all data on the current
system partition manually after installing the operating system and standard
software. Upon completion of the base backup, you can use the Recover
Base Backup function to recover the system partition to the original default
settings.
Note: Create base backup can only be used once. After the user has
performed a base backup, this operation cannot be used again. It is
recommended that this operation is performed after installing the Windows
operating system and the drivers and software shipped with the computer.
Otherwise, the backup space is insufficient.
Recover base backup: This operation recovers the computer system partition
(drive C) to the base backup state.
31039306_Q700_UG_EN_V1.1.indd 17 2009.7.3 3:10:00 PM