Lenovo System Update Solution (Deployment Guide) User Manual

Page 39

Table 12. Computer Configuration>Administrative Templates>ThinkVantage>System
Update>User Settings (continued)

Policy

Setting

Description

Mapped
Network
Drive

UNC

UNC location for the mapped network drive
(format \\server\share). Default: none

User

Use the mapdrv.exe /view command to create
an encrypted value for this field. Default: none.

Password

Use mapdrv.exe /view command to create an
encrypted value for this field. Default: none

UCSettings:

This table provides the settings for the General policy of System

Update.

Table 13. Computer Configuration>Administrative Templates>ThinkVantage>System
Update>UCSettings>General

Policy

Setting

Description

General

Billboard\
LiveFeed

System Update checks the Live Feed to get the
billboard setting. You can remove the billboard
function from System Update by clearing this value.

General

Disable

This flag is used to determine if System Update
should ignore requests for System Update to be run.
If this flag is NO, System Update will run normally.
If it is YES, System Update will not run.

General

Extras Tab

YES

turns the

Extras Tab on.

turns the

Extras Tab off.

The Extras Tab enables you to easily find the right
software, hardware, and solutions to help you keep
your system up-to-date and performing to its fullest
capacity. System Update analyzes your system and
then recommends solutions that can be used to
enhance your system. When enabled, YES is default
value and will enable you to see the extra tab. You
can disable the Extras Tab by changing the value to
NO

This table provides the policy setting for the Update Thyself function of System
Update.

Table 14. Computer Configuration>Administrative Templates>ThinkVantage>System
Update>UCSettings>HTTPSHelloSettings

Policy

Setting

Description

HTTPSHelloSettings

Update Thyself

System Update checks the Lenovo Help Center
Web site for updates for itself, even if it is
connecting to a network share repository. You
can remove the Update Thyself function from
System Update by clearing this value.

Note:

To make the policy settings take effect immediately after you configure the

settings for the ADM file, complete the following steps:
1.

From the Windows Start menu, click Run.

Type gpedit.msc /force and then click OK.

Chapter 3. Configurations