beautypg.com

2 internal connectors, Jmicron jmb363, 26 chapter 2: hardware information – Asus Motherboard P5B-E User Manual

Page 50: P5b-e floppy disk drive connector, Floppy, P5b-e sata_raid connector sata_raid

background image

2-26

Chapter 2: Hardware information

2.7.2

Internal connectors

1. Floppy disk drive connector (34-1 pin FLOPPY)

This connector is for the provided floppy disk drive (FDD) signal cable. Insert

one end of the cable to this connector, then connect the other end to the

signal connector at the back of the floppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection when

using a FDD cable with a covered Pin 5.

P5B-E

®

P5B-E Floppy disk drive connector

NOTE: Orient the red markings on

the floppy ribbon cable to PIN 1.

FLOPPY

2. JMicron JMB363

®

Serial ATA RAID connector (7-pin SATA_RAID)

This connector is for a Serial ATA signal cable. This connector supports

a Serial ATA hard disk drive that you can configure for RAID through the

onboard Serial ATA RAID controller.

The JMicron JMB363 controller item in the BIOS is set to [IDE] by default..

Before creating a RAID set using Serial ATA hard disks, make sure that you

have connected the Serial ATA signal cables and installed Serial ATA hard disk

drives; otherwise, you cannot enter the JMicron

®

JMB363 RAID utility and SATA

BIOS setup during POST.

P5B-E

®

P5B-E SATA_RAID connector

SATA_RAID

G

ND

RS

AT

A_

TX

P1

RS

AT

A_

TX

N1

G

ND

RS

AT

A_

RX

P1

RS

AT

A_

RX

N1

G

ND

This manual is related to the following products: