4 jmicron, Raid configuration, Before creating a raid set – Asus Motherboard P5B-E User Manual
Page 143: The jmicron, Windows, Os had been installed
ASUS P5B-E
5-37
5.4.4
JMicron
®
RAID Configuration
The JMicron
®
Serial ATA controller allows you to configure RAID 0, RAID 1 and
JBOD sets on the external Serial ATA hard disk drives.
Before creating a RAID set
Prepare the following items:
1. Two SATA HDDs, preferably with the same model and capacity.
2. A write-enabled floppy disk
3. Microsoft
®
Windows
®
OS installation disk (Windows 2000/XP)
4. Motherboard support CD with JMB363 driver
Complete the following steps before you create a RAID set:
1. Install the external Serial ATA hard disk drives (HDDs) on your system.
2. Set the
JMicron Controller Mode item in the BIOS to [RAID]. See section
“4.4.5 Onboard Devices Configuration” for details.
3. Enter the JMB363 RAID BIOS utility to set up your RAID configuration.
4. Create a JMB363 RAID driver disk for Windows
®
OS installation. See section
“5.5 Creating a RAID driver disk” for details.
5. Install the JMB363 driver after the Windows
®
OS had been installed.
Select Screen
Select Item
+- Change Option
F1 General Help
F10 Save and Exit
ESC Exit
v02.58 (C)Copyright 1985-2006, American Megatrends, Inc.
BIOS SETUP UTILITY
Advanced
Configure Win627EHF Super IO Chipset
HD Audio Controller
[Enabled]
Front Panel Support Type
[AC97]
Onboard 1394 Controller
[Enabled]
Onboard PCIE GbE LAN
[Enabled]
LAN Option ROM
[Disabled]
JMicron SATA/PATA Controller
[Enabled]
JMicron SATA Controller Mode
[SATA]
Serial Port1 Address
[3F8/IRQ4]
Parallel Port Address
[378]
Parallel Port Mode
[ECP]
ECP Mode DMA Channel
[DMA3]
Parallel Port IRQ
[IRQ7]
Enable or Disable
High Definition Audio
Controller