Asus Motherboard P5B-E - Manual (Page 46)

2-22 Chapter 2: Hardware information
2. USB device wake-up
(3-pin USBPW1-4, 3-pin USBPW5-8, 3-pin USBPW910)
Set these jumpers to +5V to wake up the computer from S1 sleep mode (CPU
stopped, DRAM refreshed, system running in low power mode) using the
connected USB devices. Set to +5VSB to wake up from S4 sleep mode (no
power to CPU, DRAM in slow refresh, power supply in reduced power mode).
• The USB device wake-up feature requires a power supply that can
provide 500mA on the +5VSB lead for each USB port; otherwise, the
system will not power up.
• If you are using Windows ® 2000, you need to install Service Pack 4 to wake
up the system from S4 sleep mode.
• The total current consumed must NOT exceed the power supply capability
(+5VSB) whether under normal condition or in sleep mode.
P5B-E
®
P5B-E USB device wake-up
1
2 2
3
+5V
(Default)
+5VSB
USBPW1-4
2 3 1 2
+5V
(Default)
+5VSB
USBPW5-8
USBPW910
3. Keyboard power (3-pin KBPWR)
This jumper allows you to enable or disable the keyboard wake-up feature.
Set this jumper to pins 2-3 (+5VSB) to wake up the computer when you press
a key on the keyboard (the default is the Space Bar). This feature requires
an ATX power supply that can supply at least 1A on the +5VSB lead, and a
corresponding setting in the BIOS.
P5B-E
®
P5B-E Keyboard power setting
(Default)
+5V +5VSB
KBPWR
2 3 1 2