Vollrath Hot Cold Drop-ins 4 WELL - Manual (Page 5)

www.vollrath.com
The Vollrath Company, L.L.C.
1236 North 18th Street
Sheboygan, WI 53081-3201
U.S.A.
Main Tel: 800.628.0830
Fax: 800.752.5620
Technical Services: 800.628.0832
Service Fax: 920.459.5462
Canada Service: 800.695.8560
© 2014 The Vollrath Company, L.L.C.
c
leaning
To maintain the appearance and increase the service life, clean your equipment daily.
NOTE: Do not use caustic cleaning chemicals, steel wool or commercial lime removal products to clean the equipment.
1. Remove the food containers.
2. If the drop-in was in heating mode, drain the water.
• If the unit has an automatic drain, turn the mode selector switch (B) to cold mode. This will allow the water to drain. Turn the ON/OFF switch to the “OFF”
position.
• If the unit has a manual drain, turn the ON/OFF switch to the “OFF”position. Let the water in the wells cool. Remove the drain plug to drain the water.
3. Let hot wells cool before cleaning.
4. Using a damp cloth, sponge dipped in soapy water to clean the inside of the well and the outside of the equipment.
5. Thoroughly rinse equipment with water after cleaning.
t
roubleShooting
c
hart
Problem It might be caused by Course of Action
Unit does not have power.
Unit is not plugged in. Plug unit in.
Power switch is in the “OFF” position. Turn power switch to the “ON” position.
Circuit breaker is tripped. Reset the circuit breaker.
Defective circuit or in-adequate power supply. Call licensed electrician.
Unit has power but is not operating. Unknown. Contact Vollrath Technical Services 800-632-0832.
S
ervice and
r
ePair
There are no user serviceable parts within this appliance. To avoid serious injury or damage, never attempt to repair the equipment or replace a damaged
power cord yourself. Do not send equipment directly to the Vollrath Company. Please contact the qualified professional repair service listed below.
VOLLRATH Technical Service • 1-800-628-0832