Vollrath Hot Cold Drop-ins - Manual (Page 3)

C
ountertop
W
arming and
d
isplay
3
English
O
peratOr
’
s
M
anual
12. Strip 3/8” (10 mm) of insulation (C) from the wire. There is a gauge that
shows the correct measurement to be stripped on the lever connector.
Twist the exposed wire slightly so that is stays together inside the
connector.
13. Lift lever to the up position (A).
14. Insert the stripped portion of wire into the lever connector and put lever
into the closed position (B). no bare wire can be exposed from the
connector.
15. After all the connections have been made secure the cover (A) onto
the wire channel box (D) using the hardware that was removed earlier.
Figure 3.
16. Tighten the screws (B) by hand to prevent cutting the wire insulation. See
Figure 3.
New
Terminal Block
Connection
Point
ACCESSORY
DRAIN VALVE
ACTUATOR 1
Connection
Point
56
Black
White
ACCESSORY
DRAIN VALVE
ACTUATOR 2
10
BLUE
BLUE
57 BLUE
11
BLUE
63
White
64 White
65 White
62 White
New
Terminal Block
Connection
Point
Connection
Point
Wire Channel Box - Auto Drain Wire (2 Well, 3 Well 4 Well shown)
58 BLUE
12
BLUE
Blue
Blue
Blue
ACCESSORY
DRAIN VALVE
ACTUATOR 3
New
Terminal Block
Connection
Point
Blue
ACCESSORY
DRAIN VALVE
ACTUATOR 4
New
Terminal Block
Connection
Point
Blue
Blue
Blue
White
Connection
Point
401 BLUE
400
BLUE
Blue
Connection
Point
2 Well
3 Well
4 Well
White
White
White
Figure 4. Electrical Connections.
5. Thread the fitting (B) into the well bottom (A) and tighten.
6. Repeat steps 2-5 as necessary to install more valves.
7. Remove the hardware securing the cover (A) on the wire channel box
(D). See Figure 3.
B
C
A B
D
Figure 3. strain Relief screws, Wire Channel Box and Wires.
8. Loosen the screws (B) on the strain relief.
9. Route the auto drain cords (C) through the strain reliefs.
10. Make the connections as shown in Figure 4 using the lever connectors
and blue and white wire(s) provided. Also refer to unit wiring diagram.
11. To use the lever connectors (See Figure 5):
B
A
C
Figure 5. lever Connector.