Goto function, User points: marks and waypoints (objects), Route – Seiwa Explorer 3(v.7.0) User Manual

Page 3: Create a goto, Delete a goto, Place an user point (mark, waypoint), Delete an user point (mark, waypoint), Move an user point (mark, waypoint), Edit an user point (mark, waypoint), Create a routes

press and take pressed the Softkey (1) you want to edit till a POP UP MENU appears,
moving the Cursor Knob (4) select the Page you want to assign to the Softkey, press
ENTER button (8) to confirm the selection

GoTo function

Create a GoTo

Move the cursor on the destination and then make this sequence:

press ENTER button (8), select “GOTO”, press ENTER button (8) again

Delete a GoTo

To delete a GoTo

make this sequence:

move the cursor on the GoTo position, press the Softkey “Stop”

User Points: Marks and Waypoints (Objects)

Place an User Point (Mark, Waypoint)

To place an User Point, move the cursor on the desired position

and make this sequence:

press ENTER button (8), select “MARK” or ”Waypoint”, press the ENTER button (8)

The

User Point

position is automatically registered in the chart plotter memory. Repeat this

procedure for any other

User Point

you need.

Delete an User Point (Mark, Waypoint)

To delete an User Point, move the cursor on it and then make this sequence:

press the Softkey “Delete”, press ENTER button (8), press the Softkey “Accept”

Move an User Point (Mark, Waypoint)

To move an

User Point

, move the cursor on it and make this sequence:

press the Softkey “Move”, move the cursor on the new position, press the Softkey “Accept”

Edit an User Point (Mark, Waypoint)

To edit an

User Point

(change symbol, name, color, lat/long), move the cursor on it and

make this sequence:

press the Softkey “Edit”, select field you want to edit, press the ENTER button (8)

Route

Create a Routes

To create a Route you have to position at least two Waypoints. To create a Waypoint,
move the cursor on the position you want to navigate trough, then make this sequence:

press ENTER button (8), select “Waypoint”, press ENTER button (8) again

The Waypoint position is automatically registered in the chart plotter memory. Repeat this
procedure for any other Waypoint you need to create your Route.

Add a Waypoint

To add a Waypoint in an existing Route, move the cursor on the leg between two
Waypoints and make this sequence:

press the Softkey “Insert”, move the cursor to the new position (the Route will be
automatically updated), press the Softkey “Accept”