Revolabs Single Channel System - Polycom HDX 9001/9002 User Manual
Revolabs Equipment

Revolabs Single Channel System - Polycom HDX 9001/9002 Setup Guide
N
OTES AND
C
AUTIONS
:
This setup guide will guide you through the steps needed to properly connect a
Revolabs Single Channel System to a Polycom HDX 9001/9002 video codec.
1. Connecting the Cables
2. Configuring the HDX 9001/9002 Video Codec
Note:
It is important to carefully follow these instructions in order and completely.
Otherwise your Single Channel System and/or the video codec may not function
properly. Please read through these instructions completely before proceeding.
Contact Revolabs technical support if you have any questions.
Requirements for connecting systems:
1. Revolabs Single-Channel System
2. Revolabs 2.5mm to RCA Audio Cable (included with Single -Channel)
3. Polycom HDX 9001/9002 video codec
4. Polycom Audio Adapter Cable (P/N 2457-23492-001) or equivalent*
*P
OLYCOM
HDX
9000
SERIES VIDEO CODECS HAVE PHOENIX CONNECTORS FOR AUDIO INPUT
/
OUTPUT WHILE
R
EVOLABS
F
USION PRODUCTS USE
RCA
CONNECTORS FOR AUDIO INPUT
/
OUTPUT
.
T
HE
P
OLYCOM AUDIO ADAPTER CABLE CONVERTS
TWO PHOENIX CONNECTORS INTO FEMALE
RCA
CONNECTORS
.
O
THERWISE
,
A TECHNICIAN COULD SIMPLY CUT OFF THE
ENDS OF THE
RCA
CABLES AND CONNECT PER THE DIAGRAM ON THE FOLLOWING PAGE
: