Revolabs HD Venue - Manual (Page 12)

- 12 -
1 2 3 4 5 6 7 8
on
off
Using the Rear Panel Configuration DIP Switches
DIP
Switch
Feature Off (Default) On
1 Output Mixing
Individual
Outputs
Mixed Output
2 Low Pass Filter No LPF LPF
3
Audio Output
Level
Line Level Mic Level
4 Mute Mode
Individual
Mutes
No Mutes
5 Sharing Mode
All frequencies
will be used.
Half of the
frequencies will
be used.
6 A/B Freq Groups A Frequencies B Frequencies
Changes in DIP switch configurations require a power cycle (off/on) to take effect.
Configuration Settings
DIP Switch 1- Output Mixing:
When DIP Switch 1 is OFF(default), each HD microphone has its own balanced audio output on the
Base Station. When DIP Switch 1 is switched on, the audio outputs of the two HD microphones are
mixed together and sent to both outputs.
DIP Switch 2 - Low Pass Filter:
When DIP switch 2 is OFF(default) the microphone provides the full audio bandwidth. When DIP
switch 2 is ON, a LPF is activated reducing the audio bandwidth.
DIP Switch 3 – Audio Output Level:
When DIP switch 3 is OFF(default) the microphone outputs provide a line level signal~0 dBu. When
DIP switch 3 is ON, the microphone outputs provide a mic level signal ~-40 dBu.
DIP Switch 4 - Mute Mode:
When DIP switch 4 is OFF(default) each microphone has its own individual muting capabilities. When
DIP switch 4 is ON, the microphone mute buttons are deactivated resulting in the mics always being
active and un-muted when not in the Charger Base.
300' 150' 75' 25'
7 Transmit
Power Off On Off On
8 Off Off On On