AT&T 2400 - Manual (Page 59)

Issue 2 December 1995 5-7
Load the SID Software
12. Press (F3).
After you press the key, you receive a confirmation message as shown in
Figure 5-3. The message tells you that the serial port was registered
successfully and that you need to start the voice system
Figure 5-3 Switch Link Administration Confirmation Message
13. Press (F6).
You see the Switch Link Administration screen.
14. Press (F6) again.
You see several messages indicating that the installation is still running.
When the installation process finishes, you see the following messages:
Installation of INTUITY SID Integration Package (sid)
was successful.
Insert a diskette into Floppy Drive 1.
Type [go] when ready
or [q] to quit: (default: go)
15. Remove Disk 2 of 2 from the floppy drive.
16. Enter q to quit.
The Software Install screen is redisplayed.
17. Press until you see the INTUITY Administration menu.
Restart the voice system as described in the next section.
SAVE
CANCEL
CANCEL
CANCEL