KMW Communications PAC-I - Manual (Page 25)

KMW Communications
Important: This program requires at least one available serial port (i.e., COM1, COM2, COM3, or
COM4). If the serial port is not installed or available, the following error message will appear.
Figure 4-2. Serial Port Error Message Window
Figure 4-3. PAC Program Start-up Window
• TX/RX State
The TX LED flashes when data is being transferred from the PC to the PAC and the RX
LED flashes when data is being received from the PAC to the PC.
Note: If the TX LED is not flashing when sending data to PAC, make sure that a serial
port has been opened from the Port menu. If RX LED is not flashing after sending data to
the PAC for a long time (i.e., exceeding the Timeout period), check the status of PAC if
it’s powered-on or the serial cable in between.
• USER INFO
Used to set up User ID and Password.
• BTS INFO
Used to set up Base Station (BTS) ID.
• DATA LOG
Used to read the LOG DATA from the PAC.
Page 24 of 34 Portable Antenna Controller KC-50-0001-03
User’s Guide 10/17/05