KMW Communications PAC-I - Manual (Page 22)

KMW Communications
Diagram: Forward Control (0.0° → 5.0°)
HB-X-IB-17-65-00T[a]
01/01 00:00
▶
VB1: 0.0° [ OK ]
HB1: 0.0° [ 5.0° ]
VB2: --.-° [---- ]
3. Activate antenna beam control by pressing
‘ENT’.
HB-X-IB-17-65-00T[a]
01/01 00:00
▶
VB1: 0.0° [ OK ]
HB1: 5.0° [ OK ]
VB2: --.-° [---- ]
5.7. Measurement VSWR
This menu is to measure VSWR, but is not used currently.
5.8. Memory Clear
This menu is to allow users to clear the logging data stored in memory. The current PAC-I can
store up to 400Frame logging data. If data is stored more than 395Frame while operating PAC-I,
the warning message (‘Memory Full’) will appear. In such case, the user has to print the logging
data, then perform ‘Memory Clear’ to prevent any damage to the stored data. From SET UP
menu screen, press ‘4’ on the keypad to perform ‘Memory Clear.’
1. Press ‘ENT’ key to perform ‘Memory
Clear’ or press ‘SEL’ key to cancel.
In order to minimize damage to the
data, user must print the data using
PAC PC Application program, and then
perform ‘Memory Clear.’
MEMORY CLEAR
01/01 00:00
YES : Key
NO : Key
Page 21 of 34 Portable Antenna Controller KC-50-0001-03
User’s Guide 10/17/05