KMW Communications PAC-I - Manual (Page 11)

KMW Communications
4. Preparation
4.1 PAC-I Packing List
User should make sure that there is no missing part from PAC-I Kit to prevent any control failure or
error during operation. (Refer to Section 2.1)
4.2 Power Supply/Battery
After turning on the power switch of PAC-I, user should check the battery indicator located on the top
right corner of LCD screen to verify if the battery is charged sufficiently to operate PAC-I. If this
indicator blinks every second, user needs to recharge the battery.
Figure 4-1. View of LCD Screen
Battery
Indicator
Figure 4-2. Battery Level Indicator
Battery
Indicator
Power Level
75% to 100% full
50% to 75% full
25% to 50% full
Below 25% full
If power level is below 20%, the indicator blinks every
second to warn the user to recharge.
Page 10 of 34 Portable Antenna Controller KC-50-0001-03
User’s Guide 10/17/05