iRobot Scooba 390 - Manual (Page 2)

When Scooba has completed a cleaning cycle,
empty and rinse Scooba’s tanks.
Empty Scooba
5
Remove and clean Scooba's
cleaning head and brush.
6
Replace Scooba’s tank.
Clean With Scooba
With the Clean tank filled and properly installed, place Scooba in the center of the
room, press “Power” and then press “Clean.” Scooba will begin a cleaning cycle.
Let Scooba clean until the tank is empty (approximately 45 minutes). Scooba’s Clean
light will blink to indicate that it is almost finished cleaning and that Scooba is
drying its cleaning system. The drying mode lasts 5 minutes.
See the Owner’s Manual for important tips and maintenance
instructions, or visit www.irobot.com
Open the Dirty and Clean
tanks and drain.
2
Remove Scooba’s tank.
1
Rinse the Dirty and Clean
tanks with warm water.
3
Remove and rinse
Scooba’s filter.
4
© 2007-2009 iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730. All rights reserved. iRobot and Scooba are registered trademarks of iRobot Corporation. [00014.0209.v1]
US Pat. Nos. 6,690,134 | 6,809,490 | 6,594,844. Other patents pending.
Clean Button Light
Green solid
Green blinking
What It Means
Cleaning
Scooba is drying
its cleaning head