Cirrus Logic AN271 User Manual
Cirrus Logic Hardware
Table of contents
Document Outline
- 1. GUI Installation
- 2) Click the link, “Cirrus Seismic Evaluation GUI Vxx” (xx indicates version number).
- 3) Download the file named SeismicEvalGUI_Vxx.zip onto the PC and unzip it. A folder structure ca...
- 4) Open the folder and run the setup.exe file (C:\Distribution\Volume1\setup.exe).
- 5) If the GUI has been installed previously, the Uninstall wizard will remove the older version (...
- 6) Follow the instructions presented by the Cirrus Seismic Evaluation Installation Wizard.
- 7) To run the GUI, go to:
- 2) Apply power to the target board.
- 3) The PC will detect the target as an unknown device. Using the Windows® Device Manager, go to t...
- 4) Select Install from a list or specific location then click Next.
- 5) Select Include this location in the search and click the Browse button.
- 6) Select the driver directory under C:\Program Files\Cirrus Seismic Evaluation\, then click OK.
- 7) The PC will install the USBXpress Device driver.
- 8) After installation, cycle the power to the target board.
- 9) The PC should add the USBXpress Device under Universal Serial Bus controllers in Windows Devic...
- 10) To run the GUI, go to: