RADWAG WPT/8B 300C Ramps Bed Scales - Manual (Page 7)

- 7 -
Installing standard batteries without setting the parameter
<5.5.CHr6> to value may, on powering the indicator
from mains, damage the batteries and the indicator.
Powering the scale from mains is permissible using only the
power adapter that comes standard with the scale.
2.2.2. Replacement of used batteries
Scales featuring indicator PUE C/31 series (plastic housing) enable
replacing used batteries with new ones.
Procedure:
• Open the lid of the battery compartment located in the bottom section
of indicator’s housing:
• Remove used (discharged) accumulators / batteries and replace them
with new ones, pay attention to correct polarity (+/-)marked in the
battery compartment: