WIKA IPT-11 - Manual (Page 6)

2 .5 Safety approval markings and safety tips
The safety approval markings and safety tips on the device must be
observed.
2 .6 CE conformity
This device fulfills the legal requirements of the applicable EC
guidelines. By attaching the CE mark, VEGA provides a confirmation
of successful testing.
2 .7 Fulfillment of NAMUR recommendations
With respect to interference resistance and emitted interference, the
NAMUR recommendation NE 21 is fulfilled.
With respect to compatibility, the NAMUR recommendation NE 53 is
fulfilled. This applies also to the corresponding indicating and
adjustment components. WIKA instruments are generally upward and
downward compatible.
l Sensor software for DTM IPT-1* HART, PA or FF
l DTM IPT-1* for adjustment software PACTware
l Indicating and adjustment module for sensor software
The parameter adjustment of the basic sensor functions is indepen-
dent of the software version. The range of available functions depends
on the respective software version of the individual components.
The software version of IPT-1* can be determined as follows:
l via PACTware
l on the type label of the electronics
l via the indicating and adjustment module
2 .8 Safety instructions for Ex areas
Please note the Ex-specific safety information for installation and
operation in Ex areas. These safety instructions are part of the
operating instructions manual and come with the Ex-approved
instruments.
2 .9 Safety instructions for oxygen applications
For instruments in oxygen applications the special instructions in
chapters "Storage and transport", "Mounting" as well as "Technical
data" under "Process conditions"must be noted. Furthermore the valid
national regulations, implementation instructions and memorandums
of the BG (professional assoc.) must be noted.
6 Process pressure transmitter IPT-1* Vers. 3.0 - metalic sensor • 4 … 20 mA/HART
2 For your safety
31543
-EN
-090130