2 connecting multiple devices, Connecting multiple devices – Kramer Electronics TP-200AXR User Manual
Page 12
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the PC/Audio Line Transmitter/Receiver
10
5.2 Connecting Multiple Devices
To connect multiple units in a chain as shown in
, do the following:
1. Connect the TP-100AXR to the source, as explained in section
2. Connect the LINE OUT 1 RJ-45 connector on the TP-100AXR to the
LINE IN RJ-45 connector on the first TP-200AXR.
3. Connect the LINE LOOP OUT RJ-45 connector on the first TP-200AXR
to the LINE IN on the next TP-200AXR.
4. Repeat this connection for all remaining units in the line.
5. On the last TP-200AXR press in the termination pushbuttons. Do not
terminate the devices in the middle of the line.
6. A similar chain can be connected to the LINE OUT 2 RJ-45 connector on
the TP-100AXR.
7. Connect the 12V DC power adapters to the power sockets and connect the
adapters to the mains electricity on all the units
Notes:
•
Multiple TP-100AXR units can be connected on a UTP line no
longer than 200m
•
The number of units connected depend on the required line quality
•
The lines do not have to be of equal length or configuration
1 Alternatively, you can connect the power supply to some of the units so that others are powered via the Power Connect
feature (see section
). Feeding more than three units from each power supply is not recommended. As an example, the
system in
, could be powered by two power supplies