Kramer Electronics FC-8 - Manual (Page 14)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Configuring the FC-8 Wi-Fi - RS-232 Bridge
10
Table 3: FC-8 Serial Net Configuration Parameters
Parameter Possible Values Notes
MAC Address Ethernet hardware address (read-only)
Bootblock Version For technical use (read-only)
Serial Number Factory serial number of the device (read-
only)
Web Server Status Message Must be I/OK (read-only)
Firmware Version Must end with b17 or above (read-only)
Hardware Version For technical use (read-only)
Active IP Address 192.168.3.2 (Default) Active IP address of the FC-8
Subnet Address 255.255.255.0 (Default)
IP Gateway 0.0.0.0 (Default)
Wireless LAN SSID Alpha-numeric
Kramer-FC8 (Default)
An ad-hoc network must
begin with the character “!”
Network name (SSID)
IP Registration Host Server
Name
nnn.nnn.nnn.nnn:ppp
Where:
nnn.nnn.nnn.nnn =
a server name or IP address
ppp = 0..65535
If Registration Host Server
Name is empty, no IP
registration server name is
defined.
192.168.3.1 (Default)
The Registration Host Server Name is used
to locate and establish a connection after
FC-8 establishes an Internet session
connection as a result of an explicit
command or as a result of automated
Internet session establishment procedures.
The dynamically assigned IP address is sent
to the server in ASCII form, after which the
socket is closed. See Socket IP Registration.
It is assumed that the host server is
"listening" on port number.
FC-8 registers itself by opening a socket to a
registration server and sending its ID
information and current IP address. When
the Registration Host Server Name
parameter contains a value, the FC-8
establishes a socket to the server defined in
Registration Host Server Name during the
registration procedure. When a socket is
established, FC-8 transmits its ID information
and current IP address in the following
format:
FC-8- S/N: version:
HN: IP: Port:
or 80 or 0>”
The registration socket is then closed.
SerialNet Listening Port 0 to 64000
10000 (Default)
Socket Type 0 – TCP (Default)
1 – UDP
Host Server & Port nnn.nnn.nnn.nnn:ppp To configure the FC-8 as an active station,
see section 6.4.
Security Type 0 – N
1 – WEP64
2 – WEP128
3 – WPA
4 – WPA2
No security