Kramer Electronics FC-8 - Manual (Page 12)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Configuring the FC-8 Wi-Fi - RS-232 Bridge
8
Figure 4: Wireless Network Connection Window
5. If the Kramer-FC8 network does not connect:
Click on Kramer-FC8 to open the network and
click Change Advanced Settings.
Choose to highlight Internet Protocol (TCP/IP)
and click Properties.
Make sure Obtain an IP address automatically is
selected.
6. Begin operating the device as described in section 7 or if necessary, change
the FC-8 configuration as described in section 6.3.
6.3 Changing the FC-8 Configuration
The FC-8 is normally configured to work as a listening station in an ad-hoc,
peer-to-peer network or over an access point such as a router to connect to
the Internet. (To configure the FC-8 as an active station, see section 6.4.)
To connect the FC-8 to another network you must change its configuration
using a built-in Web page configuration program over an Internet browser.