Kramer Electronics RC-80 - Manual (Page 15)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the Remote Control Machine
12
When controlling via RS-232, set the machine # to 1 on each machine (the
controllers and the switcher)
The STATUS display on both the remote control panels illuminate and after a
few seconds will show the status of the connected switcher.
If a “
” message appears, refer to section 7.1.
After the system is connected and powered, run the Windows®-based Kramer
control software on your PC
1
To the RS-232
Port of a
Kramer Switcher
Second
Remote Control
First
Remote Control
Figure 4: Connecting the RC-160 Remote Control 2
1 If the PC was connected
2 The dotted lines indicate an optional connection