Kramer Electronics VS-626 - Manual (Page 10)

Your VS-626 (VS-828) Video Audio Matrix Switcher
7
Table 1: Front Panel VS-626 6x6 (VS-828 8x8) Video / Audio Matrix Switcher Features
# Feature Function
1 IR Receiver The red LED is illuminated when receiving signals from the infra-red remote
control transmitter
2 POWER Switch Illuminated switch for turning the unit ON or OFF
3 OFF Button An OFF-OUT combination disconnects that output from the inputs; an OFF-ALL
combination disconnects all the outputs
4 ALL Button Pressing ALL followed by an INPUT button, connects that input to all outputs 1
5 OUTPUT Buttons Select the output to which the input is switched
6 INPUT Buttons Select the input to switch to the output
7 7-segment Display Displays the selected audio 2 or video 3 input switched to the output (marked
above each input)
8 VIDEO Button When pressed button is illuminated and all actions relate to video
9 AUDIO Button When pressed button is illuminated and all actions relate to audio
10 AFV Button When pressed button is illuminated and all actions relate to video and audio
channels. Audio channels follow the video channels
11 STO (STORE) Button Pressing STO followed by an output button stores the current setting 4
12 RCL (RECALL) Button Pressing the RCL button and the corresponding OUTPUT key recalls a
setup from the non-volatile memory. The stored status blinks. Pressing a
different OUTPUT button lets you view 5 another setup. After making your
choice, pressing the RCL button again implements the new status
Table 2: Rear Panel VS-626 6x6 (VS-828 8x8) Video / Audio Matrix Switcher Features
# Feature Function
13 EXT. SYNC BNC Connector Connects to the external SYNC source
14 AUDIO INPUTS RCA Connectors Connect to the audio sources
15 VIDEO INPUTS BNC Connectors Connect to the video sources (from 1 to 6 / 8)
16 SYNC Source Selector Button Pushing in selects the (EXT) external sync source on the SYNC
connector; releasing selects the (IN 1) internal sync on the
VIDEO IN 1 connector
17 AUDIO OUTPUTS RCA Connectors Connect to the audio acceptors
18 VIDEO OUTPUTS BNC Connectors 6 Connect to the video acceptors (from 1 to 6 / 8)
19 RS-485 Connector RS-485 port on detachable terminal block
20 RS-232 DB 9F Connector Connects to the PC or other Serial Controller
21 Setup Dipswitches DIP 1, 2, and 3 for machine SELF ADDRESS #; DIP 4 for
RS-485 termination, DIP 5 for reply from switcher to PC,
DIP 8 for RS-232 / RS-485 communication
22 Power Connector with Fuse AC connector enabling power supply to the unit
23 REMOTE IR 3.5mm Mini Jack Connect to an external IR receiver unit for controlling the
machine via an IR remote controller (instead of using the front
panel IR receiver) 7
1 For example, press ALL and then Input button # 2 to connect input # 2 to all the outputs
2 When the Audio button illuminates, that is, when the audio breakaway mode is selected
3 When the Video button illuminates, that is, when the video breakaway mode is selected
4 For example, press STO and then the Output button # 3 to store in Setup # 3
5 Only view, nothing is implemented at this stage
6 For RGBS applications, one of the sync channels (H or V) may be used for the S channel
7 Optional. Can be used instead of the front panel (built-in) IR receiver to remotely control the VS-626/VS-828 (only if the
internal IR connection cable has been installed)